CNCA -3KT. Programming manual.(Chapter 3)

Подробности

Опубликовано 02.04.2013 00:42

115 PM: 23: <FA> ;

Repeats FA from the 23rd needle to the end of the needle bed <...> repeats the momentary position to the end or the pattern section within <...> is copied to the end.

115 PM: 23: <FA 555>;

CNCA -3KT. Programming manual.(Chapter 2)

Подробности

Опубликовано 26.02.2013 00:42

     The control—commands of the machine offers   the maximum ease of operation.  The micro-computer is loaded with a programme, using Sintral Software.

Sintral means: Stoll INTerpreter - computer software for ALL Selectanit machines.

CNCA -3KT. Programming manual.(Chapter 1)

Подробности

Опубликовано 18.02.2013 17:53

     The main computer, which in future we shall refer to just as a computer, then gives its instructions in the form of electrical signals to the electronic control. The electronic control switches the magnets, as for example yarn feeders,strikers and needle selection. The electronic control on its side passes information back e.g. when the carriage runs through the reversal